G4 ST Steel Universal Joint (2) (for V1RRR front as well)
To cure previous universal drive shaft problems,we have been working hardly to get the right design & right material. Normally, the drive shaft is either too soft or too rigid. Soft drive shafts will cause bending problems; rigid drive shafts will break. Now, we have come up with the new design & new material to balance the overall strength. Here you go.
Features
1. Never lose your drive shaft
2. New design with new ST steel, 200% stronger
3. Adjustable length
4. Better performance
5. More parts included
No chance to lose drive shafts
Very often that we can find someone trying to find their dog bones (drive shafts) on the track, probably because of a crash or too much steering travel. Normally, it's quite difficult to get their dog bones back. They may lose the race & spend money because of the dog bone loss. K Factory ST steel universal joint is the right choice to cure this problem.
As both bog bone & wheel shaft are precisely combined together by the latest design & technology, you will never lose drive shafts again.
New design with new generation ST steel, 200% stronger
In addition to the missing problem, drive shafts may be bent or break because of crashes. If the drive shaft is not 100% straight,
it won't rotate freely & the transmission efficiency will be very poor. You will suffer bad acceleration & low top speed. Of course, if the drive shaft breaks, it is also impossible to drive the car.
To prevent possible breakage or bending, we need high quality material for universal joints.
After several years' research, finally, we find the right material to produce high quality steel parts. With the new ST steel & advanced design, the new G4 universal joint is now almost 2 times stronger than before. Precisely machined from ST steel, hardened for higher strength & finished with black rust preventive coating are what you can easily find on the new ST steel universal joints.
The new cone shape drive shaft & thicker ball end are what we do to make them even stronger. To identify the new design, you can find K Factory logo etched on the drive shafts. They are the strongest universal joints you can find in the market.
Adjustable length
The length of the new ST steel universal joint is adjustable. As there are two different pin positions available on the wheel shaft, the result is two different lengths can be used. We preset the longer length to be used for the front & the shorter one for the rear. With the longer setting for the front, you don't need the one way washer anymore.
In addition to the G4, these universal joints can be used on other cars as well because of the adjustable length.
Better performance
High quality finish by the most advanced CNC machine is the main reason why they can rotate like never stop. Every part can fit together very well & run smoothly. They have almost zero backlash for you get the best acceleration out of corner. This helps the car to increase acceleration & top speed. The polish part of wheel shaft is only good for look, but also for the perfect fit with bearings.
Washer & alum. flanged nuts included
Blue thin alum. 4mm flanged nuts are included for you to further hop-up your car. You don't need to spend extra money for these cool lightweight flanged nuts.
In addition, 10.1x13x0.3mm washers are for you to adjust the clearance.
After the wheel installation, if the distance between wheel-push-in & wheel-pull-out is too large, please install the washer. The washer will diminish 0.3mm distance.
K Factory always takes care of the necessary parts you need. With all these important & cool features, the new ST steel universal joint is the performance hop-up you need.
Το προϊόν αυτο προστέθηκε στον κατάλογό μας την Παρασκευή 07 Αυγούστου, 2009.